B1G's Tamiya TT-01 (now with video)
So I was working on a deal for a TT-01D, the price was amazing but the deal went south and I figured I would see what I could find floating around on eBay unfortunately no D-spec ones where listed but there was this used RTR TT-01 going for a low amount so I figured I would try my luck.... I ended up wining the auction for $65 and after what seems like forever it is finally here:
http://i250.photobucket.com/albums/g...1/IMG00221.jpg Comparison shot... 1:10 TT-01 1:18 ProPulse 1:28 92mm Mini-Z chassis 1:28 XMOD Monster size difference... http://i250.photobucket.com/albums/g...1/IMG00222.jpg http://i250.photobucket.com/albums/g...1/IMG00223.jpg Full time AWD chassis. http://i250.photobucket.com/albums/g...1/IMG00224.jpg 23T Tamiya Super Stock Type-RR motor http://i250.photobucket.com/albums/g...1/IMG00225.jpg Graphite cross bar http://i250.photobucket.com/albums/g...1/IMG00226.jpg Alloy drive shaft http://i250.photobucket.com/albums/g...1/IMG00227.jpg Futaba 2 Channel RX 75MHz http://i250.photobucket.com/albums/g...1/IMG00228.jpg Duratrax AC/DC Pirhanna charger http://i250.photobucket.com/albums/g...1/IMG00229.jpg 2 sets of Venom 3000mah NiMh batteries http://i250.photobucket.com/albums/g...1/IMG00230.jpg 2 sets (1 new, 1 very very used) of ABS drift tires. It has a Porsche body on it that is in fairly decent condition and a Mitsubishi body that is trashed. Futaba T2PH 75MHz TX. It was missing the body clips but otherwise is good to go, I used 1:18 ProPulse clips to set it up until I buy some replacement ones. I've heard that the Venom battery packs aren't wonderful so I'd like to upgrade those at some point, ideally I would like to go to liths but as that will require buying a new charger I'll just have to deal for the time being, the second pack may be going into my ProPulse. It has the soft rubber tires installed at the moment but I'd like to move towards drifting, I'm going to go for a few basic upgrades like bearings, graphite chassis, allow, etc, but that will all be as time and money allows. Let me know what you think :) |
wow it looks pretty clean, and looks A LOT better than mine, lol, looks like your gonna have fun :D
|
Thanks :) You have a bit of a battle with yours but it will get there....
Whats annoying me is the handset needs 12 AA batteries which I don't currently have!! |
ouch thats a bit too much, all of mine use 8, well i should be getting my rc18 today and lets see how many that needs... you can always throw in some TX batteries, or buy some, i know some places sell them and you recharge it through the remote
try these: http://www.hobbypeople.net/prdcls/battr01.asp yea mine might take a while, too many things to decide from, should i get a $500 2.4ghz or a $400 2.4 ghz or a $50 2.4 ghz? should i get a Novak BL system or a CC system.. what servo to buy... i think i might go nuts or my head might explode before i finish it :lol: |
Looks nice BIG. For the batteries I would for sure recommend orion. I have a 5100mah battery and it does really good. Very reliable and just a all around good battery. When you go to upgrade your charger I would say get a duratrax onyx charger. I have one and it does everything from lipos,lion,nimh,nicd,and I think 2 more. If you go lith go brushless :)
You should get a mustang body lol. Anyway looks great whats the major differences between the TT-01 and the TT-01D? |
Quote:
and i think u were thinkin of LiFe but idk what else it might charge batteries |
Quote:
Definitely going to go lith and brushless!! :) Working on something special for the body but most likely it will be a Mustang :) |
Quote:
Ahh yes lol that was the last one. Thanks I knew if was some combination of L-I-E-F just could not think of it lol. ;) Quote:
Lol once you go there you never wanna come back. plus in the snow just add some block tires and lift it and you can rally lol. |
yea, ive heard that the tt-01 makes a great rally car, or you can but the new Rustler VXL, which is even better for snow:D, and just 1 questions. is this your first 1/10(i know its a bit of a stupid question, but i couldnt find anything else in the 1/10 section that is your, unless i'm becoming blind O.O)
|
Quote:
|
Quote:
|
Quote:
|
Drooling, get ahold of me when you get bored with it:)
|
Quote:
Quote:
|
OK still figuring out the charger, it seems pretty intelligent allows you to program in 3 different packs of different types NiCd / NiMh, different MAh etc... then takes about 10 minutes to charge the pack to full which gives maybe 20 minutes of run time... I need to find the instructions because I feel like I should be getting more from these packs.
Here are 3 quick crappy videos of my driving the car in my kitchen: 1 of 3 drifting in a small space :) OK I have the ABS drift tires fitted for this run, as you can see fairly early on one of them isn't fitted correctly as it comes flying off from then on I just drive around without getting any real drifting going....
2 of 3 drifting in a small space :) Switched to the soft compound grip tires for this run. Got a bit of drifting, mostly just attacking the cats and going round and round in circles but a few times (probably not on camera) I managed to pull the nose out of the spin and start sliding. NEED MORE SPACE!!!
3 of 3 drifting in a small space :) Well at the end of the last video I wiped out the cats water bowls so on this run despite the better camera angle I couldn't get any grip due to a wet floor :( Will have to get it out for a burn when the snow melts!!
As you can see I need a lot more space and practice to actually get a drift going but at least the cats liked it!! |
hahahaha niceeeee cats look terrified
|
congrats on your score...personally i think the porsche body is sweet...i beleieve i have seen mustang bodies for these...now you got me on ebay hunting for one LOL
|
How solid of a base do you think this car is? I'm wanting to build an all out lipo/brushless top speed car and just trying to find a decent platform. I have 4 tamiya F1 cars but they are RWD and very hard to drive with even mildly modded motors. I think they are the ta01 chassis, cant remember right now but thats irrelevant to my question.
|
Quote:
|
Quote:
Quote:
|
All times are GMT -4. The time now is 10:35 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.