XmodSource.com

XmodSource.com (http://www.xmodsource.com/forum/index.php)
-   The XMS Repair and Modification Manual (http://www.xmodsource.com/forum/forumdisplay.php?f=43)
-   -   Fet just fried and motor issues (http://www.xmodsource.com/forum/showthread.php?t=19868)

IHateMakingUserNames 11-20-2010 02:03 PM

Fet just fried and motor issues
 
My TC evo fets just fried which is surprising since it was running last night without any problem. There are a couple of things that I wasn't sure about on the motor when I checked it. The little brown tab between the two wires was broken and the little metal "wires" were touching. The only thing that was bugging me was the fact that I didn't change anything on it from when I ran it last night and it was running without any issues. So now I need to know if the issue could be caused by the "noise" rf being broken or if it was just a freak thing. I'm also now looking for a stock evo board and stock evo motor as a result lol.

reaper 11-20-2010 03:09 PM

by little thing
i take it you have cracked a capacitor on the motor , if this is the case and the wires were touching then thats your problem you have just put a dead short across your board

best way i can think of blowing fets

IHateMakingUserNames 11-20-2010 05:19 PM

That's what I thought, if I could seperate the wires again, and replace the FETs do you think it would run again or will I have to get a new motor as well?

reaper 11-20-2010 05:25 PM

it should be fine
seperate the wires and try the motor on a seperate battery just to be sure but i doubt it will have damaged the motor

IHateMakingUserNames 11-20-2010 07:02 PM

the motor runs when the wires are seprated so once I get new FETs and the V2 chip like you suggested it should run alright and also like you said I can run a faster motor:D , I'll just have to watch the wires. thanks for the help.


All times are GMT -4. The time now is 04:01 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.