jollyboss
05-13-2007, 11:55 AM
Hello!
I think there's a little higher-cost but less-painful solution to run ho motor on xmods:but it's just an idea:
I thought about putting this receiver(the smalles on 27Mhz I've found)
http://cgi.ebay.com/Mini-X-MX-RX-Receiver-for-1-24-4WD-Mini-X_W0QQitemZ6023444827QQihZ009QQcategoryZ19168QQrdZ 1QQssPageNameZWD1VQQcmdZViewItem
this esc(it's less than 1'x1'):
http://cgi.ebay.com/MOPED-V16R-Plus-100-Digital-Circuitry-ESC-Hi-Frequency_W0QQitemZ280113545422QQihZ018QQcategoryZ 34056QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
and a micro servo,a 9gr type)
I've ordered the receiver,I'll keep updated...
I've gone for this conversion due to the waste of thime to put stacked fets on that eb with that tiny and low quality servo.
Of course with this convesrion isn't possible to put the command logic,light,but you can safely run all the hottest motors on the market.
Another conversion I'm going to try is to put a nanodragon2(mini inferno clone)electronic on xmods.It has rx/esc integrated(with esc capable of 400 clas motors)and a standard plug for the servo.
I think there's a little higher-cost but less-painful solution to run ho motor on xmods:but it's just an idea:
I thought about putting this receiver(the smalles on 27Mhz I've found)
http://cgi.ebay.com/Mini-X-MX-RX-Receiver-for-1-24-4WD-Mini-X_W0QQitemZ6023444827QQihZ009QQcategoryZ19168QQrdZ 1QQssPageNameZWD1VQQcmdZViewItem
this esc(it's less than 1'x1'):
http://cgi.ebay.com/MOPED-V16R-Plus-100-Digital-Circuitry-ESC-Hi-Frequency_W0QQitemZ280113545422QQihZ018QQcategoryZ 34056QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
and a micro servo,a 9gr type)
I've ordered the receiver,I'll keep updated...
I've gone for this conversion due to the waste of thime to put stacked fets on that eb with that tiny and low quality servo.
Of course with this convesrion isn't possible to put the command logic,light,but you can safely run all the hottest motors on the market.
Another conversion I'm going to try is to put a nanodragon2(mini inferno clone)electronic on xmods.It has rx/esc integrated(with esc capable of 400 clas motors)and a standard plug for the servo.