View Full Version : need help!!!!
i know that the wires connected to the batteries disconnected.....but i dont know how to take the battery tray off so i can get to the wires....oh yea its a evolution mustang
mini-z drift
04-07-2007, 06:32 PM
okay take a knife or somethin thats thin and a bit wide. right were the battery clip clips on to the tray, right above there should be a groove. put a knife or thin wide thingamabob and push down . do that to each side until it comes off.
Darkmagik
04-07-2007, 07:25 PM
okay take a knife or somethin thats thin and a bit wide. right were the battery clip clips on to the tray, right above there should be a groove. put a knife or thin wide thingamabob and push down . do that to each side until it comes off.
i have no idea what you tried to say but ok
4banger
04-07-2007, 08:09 PM
"thingamabob and push down":rolfsm:
librarianliam
04-08-2007, 12:31 AM
theres 4 tabs that hold it on to the bottom after you take out the screws that is what the thingamabob is...
bondo
04-08-2007, 05:24 AM
remove the board cover.
remove the board.
now you should see the four tabs mentioned above.
using 2 flathead screw drivers, place one in the slot for a tab and pry away from the u-channel(where the switch rests) with one and pry down between the tray and board housing with the other.
repeat for all four tabs and your done.
cheers,
bondo
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.