View Full Version : 6 cell question
adamn84
02-13-2007, 07:33 PM
I was bored this afternoon, so I went out to radio shack and got a battery holder to do the 6 cell mod. After a first attempt disaster, putting my primary car out of commission for a while, I got it installed on my backup car.
My question is can I use the 6 cell with my pnracing motor?
I'm pretty sure it'll be ok but I wanted to be sure, as I'm down to my last car. I don't want to fry the board or overheat the motor or something.
DRFTKO
02-13-2007, 07:58 PM
which PN Racing motor are you planning on running?
adamn84
02-13-2007, 08:00 PM
Speedy 05 bb, the one that runs on stock fet's.
WRX Ryder
02-13-2007, 08:03 PM
hmm i thought yu can put it with any motor and any mods?
BlackSky909
02-13-2007, 09:11 PM
hmm i thought yu can put it with any motor and any mods?
6cell? You pretty much can, shouldnt be a problem.
adamn84
02-13-2007, 09:24 PM
Thats what I figured.
2 more things I thought of though:
I didn't use heat shrink on the wires, only electrical tape. Will that be ok?
Also, will the s2 metal heatsink be enough? or do I need a new one?
BlackSky909
02-13-2007, 09:43 PM
Thats what I figured.
2 more things I thought of though:
I didn't use heat shrink on the wires, only electrical tape. Will that be ok?
Also, will the s2 metal heatsink be enough? or do I need a new one?
Electrical tape will be fine. About the heatsink yes that will be fine, but with my own theory I dont think the heat sink is anything but dead weight but thats just me.
adamn84
02-13-2007, 09:57 PM
Cool, thanks for the help.
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.