titan/h2 body raise

[mycrors4]

I noticed that people wanted to raise their titan/h2 bodies, which is different than raising the f150
What you'll need:
A screw driver
A nut driver
3 LONG screws(not shown)
9 2-56 hex nuts from radioshack(they come in a pack of 40 and can be used as wheel nuts as well)
and yes the little boy in the pic is me when i was young

http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise008.jpg

first you flip the front clip(for the people who want details. stock height of body from ground to fender is 3.8cm with off road kit tires with stock towers/arms, and flipping it raises the front up from 3.8cm to 4.3cm)

http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise002.jpg

now take the rear clip off the titan and put long screws in the holes then put 3 nuts and screw them to the top on each screw like i did(3 nuts = .5cm)

http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise004.jpg

now screw everything back on then put on your body

http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise005.jpg
http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise006.jpg
http://i326.photobucket.com/albums/k436/hibisi/Xmods/xmodtitanraise007.jpg

now for the hummer do the same thing but use 2 nuts on each screw instead of 3).

Enjoy :D

[kendallcschm]

nice but not too much of a lift :-P

[xmodzracer]

I'm sure you can adapt with longer screws

[mycrors4]

nice but not too much of a lift :-P

5mm lift is like putting on offroad kit and maybe a little higher :D

I'm sure you can adapt with longer screws

of course you can, i just didnt have any with me :(

[The devils playground]

the front clip part doesnt work for the front on the hummer