Widening the Stance of your car.

[Bananabrain]

Difficulty 3/10

Takes about 10-15 Mins Giver er' Take a Few.

This is a Tut on how to Widen Your Stance of your xmod to help fill in the wheel Wells on your 1/24 or 1/25 Scale Muscle Car Bodies & It Lifts the Rear up for More of a agressive look on your car.

Step #1
Materials Needed:
Xmods Screw Driver
Exacto Knife or Hobby Knife
Xmods Chassi
Truck Lower Rear Left & Right Arms
Stock Truck Upper Rear Suspension Piece or Truck Lowering Upgrade Upper Rear Suspension Piece
2 truck dog bones
Rear Truck Knuckles left & right
2 Short Screws
2 Truck Shocks
Needle Nose Pliers
http://i362.photobucket.com/albums/oo63/bananabrain_07/001-19.jpg

Step #2
Take The Stock or Lowering Suspension Piece & Cut it in Half with the Needle Nose Pliers.
http://i362.photobucket.com/albums/oo63/bananabrain_07/002-18.jpg
Like The Picture Below
http://i362.photobucket.com/albums/oo63/bananabrain_07/003-15.jpg
Step #3
Now Put the Knuckles, Lower arms & Dog bones on the rear of your car. After you pulled the rear gear case off.
http://i362.photobucket.com/albums/oo63/bananabrain_07/005-12.jpg
http://i362.photobucket.com/albums/oo63/bananabrain_07/004-15.jpg
Step #4
Then Take the Male Part of the shock & trim it down about 2-3mm, so the suspension works on the car.
http://i362.photobucket.com/albums/oo63/bananabrain_07/007-6.jpg
Go ahead and attach your shocks here & lossen the screws on the knuckles.
http://i362.photobucket.com/albums/oo63/bananabrain_07/008-6.jpg
Step #5
Now Enjoy your new look for your car.
http://i362.photobucket.com/albums/oo63/bananabrain_07/009-7.jpg

http://i362.photobucket.com/albums/oo63/bananabrain_07/010-4.jpg

http://i362.photobucket.com/albums/oo63/bananabrain_07/011-2.jpg


Comments & Suggetions Welcome.