Help please if you have a TS-4N

[deckerz]

well some of you know i have a thunder tiger ts4n. i am having problems with the throttle linkage, i have the servo the right way. It says in the manual that when the stick is pushed forward to full throttle the carb should be fully open and brake dissengaged but its not possible because when the throttle is fully pushed forward the carb only has a little gap in it and the brake is engaged :S i dunno if there is a servo that goes anti-clockwise but if anyone could help me out?

[reaper]

ok does it open fully if you brake ?

if it does then you need to find the "servo reverse" switch on your transmitter

[deckerz]

well fully open in neutra.

[reaper]

unscrew the servo horn , let your transmitter go to centre then push the throttle closed
now replace the horn keeping the throttle closed as you do

[deckerz]

thanks but its a dodgy setup to the one in the pictures and iv already done all that anyway and it just pushes the carb so it has a little gap in it when iv got throttle on and in neutral its fully open and its not right. Even followed the parts setup 3 times to make sure its how the pics show and its not possible.

[reaper]

nothing dodgy about it , it just needs setting up

if you follow what iv put above this will centre your servo and carb
then you will need to flick "channel 2 servo reverse" on the transmitter

[deckerz]

"channel 2 servo reveverse", will that make the servo turn anti-clockwise instead?

[reaper]

yup thats exactly what it does :)

[deckerz]

ok thanks iv got it all setup and working now but cuts out because i dont have a manifold gasket.

[reaper]

go to halfords or road and rally and buy a sheet of gasket paper to make your own :)

the LHS will charge you a fortune for them

[deckerz]

oh yeah, theres camerons motor stores just at the top of the road, they have it. thanks again.