PDA

View Full Version : parts for my mini-z


XmodzICON82
04-07-2009, 06:14 PM
i have a mr-015 and i notice that when i go to web sites for upgrades for it, i mostly find mr-02 parts....is there a reason for it and if so what is it...can the mr-02 parts fit the mr-015 and if so which ones because i want to upgrade mine so i can race it around at work when there is no-one there or in my house...we have a tiled floor that just got waxed not too long ago...any information would be appreciated....

SkylineLvr
04-07-2009, 06:18 PM
From what I have read the mr-02 parts will fit the mr-015. I think all the parts can actually fit. What I read said that you can change an mr-015 into a mr-02

XmodzICON82
04-07-2009, 06:19 PM
where did you find the reading you're talking about so that i can read and understand as well...but thanx...

SkylineLvr
04-07-2009, 06:39 PM
atomicmods

XmodzICON82
04-07-2009, 07:23 PM
i read throught testimonials and the Q & A section and couldn't find where it says anything about the parts are interchangeable...i may have missed it or read over it but i didn't see it....

SkylineLvr
04-07-2009, 08:59 PM
Check out there mini-z page and click on a mr-015 ready set. It says that most parts are interchangeable with the mr-02

Skv012a
04-07-2009, 11:14 PM
Go to Kyosho.com and find manuals, read through the exploded view and understand whatever you need to. 01, 02, and 15 share a few parts. 02 and 15 share 95% except for board cover, cover small parts, and tie rods.

Add me on YIM and I'll help you setup your 15 since I had the balls to choose this chassis as my first/primary.