integraoligist
01-12-2005, 10:57 PM
ok, my buddy came over with his Supra Xmod (long driveshaft) and here is a pic of my Integra 1:25 scale body on her with him holding it, in place...
http://image34.webshots.com/34/8/94/17/250189417ElUOfq_ph.jpg
or this link:
http://image34.webshots.com/34/8/94/17/250189417ElUOfq_ph.jpg
as you can see, it dosent lineup to good wheel well-wise...
so, the only reason for the Drive shaft is for the AWD, correct?
If so, then if i keep her 2wd and move the rear end (moving the gear on the motor to the end) how would i "extend" where the screws go into? thoughts?
Thanks all!
http://image34.webshots.com/34/8/94/17/250189417ElUOfq_ph.jpg
or this link:
http://image34.webshots.com/34/8/94/17/250189417ElUOfq_ph.jpg
as you can see, it dosent lineup to good wheel well-wise...
so, the only reason for the Drive shaft is for the AWD, correct?
If so, then if i keep her 2wd and move the rear end (moving the gear on the motor to the end) how would i "extend" where the screws go into? thoughts?
Thanks all!