aquaman
02-24-2008, 09:11 PM
1. Do the steering knuckle trim first.
2. Slipped a piece of heat shrink tubing over the end piece and begin shrinkage process.
3. Use screwdriver to pierce a small hole through through the tierod hole.
4. You may have to "work" the hole in the heatshrink because fitting the tierod initially is a bit too stiff for the servo to handle.
http://i12.photobucket.com/albums/a238/aquaman12/CIMG5233.jpghttp://i12.photobucket.com/albums/a238/aquaman12/CIMG5231.jpg
2. Slipped a piece of heat shrink tubing over the end piece and begin shrinkage process.
3. Use screwdriver to pierce a small hole through through the tierod hole.
4. You may have to "work" the hole in the heatshrink because fitting the tierod initially is a bit too stiff for the servo to handle.
http://i12.photobucket.com/albums/a238/aquaman12/CIMG5233.jpghttp://i12.photobucket.com/albums/a238/aquaman12/CIMG5231.jpg